SUPPORT & TROUBLE SHOOTING

1. How to trouble shoot over WiFi

2. How to unbind efield license

3. How to setup and receive corrections using Trignet

4. How to check that the base is transmitting corrections

5. How to update firmware on receiver

6. How to update beta version of firmware

7. How to change base settings from manual to average single

8. How to change the project co-ordinate system on efield

9. How to configure two base outputs

10. How to flash GNSS receiver

11.How to set-up RTK corrections for ntrip caster

12. How to troubleshoot RTK settings over LoRa Radio

13. How to set up rover over efield

14. How to check that the base is transmitting corrections

15. How to set up a base over known point using cape system

16. How to change coordinate system in flow 360

17. Set up Reach RX to receive corrections

18. What each LED lights on Reach RS2+ indicate

19. How to do a line stakeout with offset and intervals

20. How to trouble shoot drone converging